R5910599 /00 MDSC-842730
4.3.5 Auto search
About auto search
By enabling the input selection auto search function, the display will automatically detect the connected
source and display it on the screen.
To enable/disable auto search
1. Bring up the OSD main menu.
2. Navigate to the Input Select menu.
3. Enter the Auto search submenu.
4. Enable/Disable auto search as desired and confirm.
4.3.6 Failover input
About failover input
This function allows the display to automatically switch to a failover (backup) source in case the main source
(DisplayPort or HDMI) is missing. The display will automatically restore the main source once the signal is
back.
The available failover inputs for your display are:
• None
• DVI
• SDI
The failover input can only be selected when both
1. the Auto search function is disabled (see “Auto search”, page 30), and
2. the PiP/PaP Modes function is disabled (see“Picture and Picture input”, page 30 and “Picture in
Picture input”, page 31).
If any of both functions are enabled then failover will be disabled and made unavailable. As soon as
both functions are disabled again, failover will be enabled and made available again with the
selected failover input.
The failover input will be activated within about 7 seconds after the main source has been lost.
During the transition from main to failover input and vice versa, a text message is visible to inform
the user.
The main source can be changed while the failover input remains unchanged. During the selection
and synchronization of a new main source the failover function is temporary (7 sec) disabled.
To select the failover input
1. Bring up the OSD main menu.
2. Navigate to the Input Select menu.
3. Enter the Failover Input submenu.
4. Select one of the available failover inputs and confirm.
4.3.7 Picture and Picture input
About Picture and Picture input
This function allows the display to show a second input source on the left side of the display. The Primary input
(main source) is still displayed on the right half of the screen.
The possible Picture and Picture combinations between the Primary input (main source) and the Secondary
input (PaP image) is displayed in the following table.
Advanced operation
To Next Page
Loading...
