Barco MDSC-8427 - Picture in Picture Mode; Picture in Picture Position; Picture in Picture Transparency; Configuration Menu

R5910599 /00 MDSC-842732
4.3.9 Picture in Picture mode
About Picture in Picture mode
The available Picture in Picture modes for your display are:
• Large PiP: 35% of display horizontal size in top or bottom of right corners
• Small PiP: 25% of display horizontal size in top or bottom of right corners
• None: Disable the Picture in Picture
To select a Picture in Picture mode
1. Bring up the OSD main menu.
2. Navigate to the Input Select menu.
3. Enter the Picture in Picture Mode submenu.
4. Select one of the available Picture in Picture modes and confirm.
4.3.10 Picture in Picture position
About Picture in Picture position
The available Picture in Picture positions for your display are:
• Bottom right
• Top right
To select Picture in Picture position
1. Bring up the OSD main menu.
2. Navigate to the Input Select menu.
3. Enter the PiP Position submenu.
4. Select one of the available PiP positions and confirm.
4.3.11 Picture in Picture transparency
About Picture in Picture transparency
The available Picture in Picture transparencies range selectable for your display is between:
• 0: No transparency
• 10: Maximum transparency (roughly 37%)
To select Picture in Picture mode
1. Bring up the OSD main menu.
2. Navigate to the Input Select menu.
3. Enter the PiP transparency submenu.
4. Select one of the required PiP transparency value and confirm.
4.4 Configuration menu
4.4.1 Information
About information
The available information items for your display are:
• Model (commercial type identification)
• SW package (display firmware identification)
• Main board release (hardware and firmware identification)
• Keyboard release (hardware and firmware identification)
Advanced operation