4.1.2.4 Lamps Menu
Mode
Set lamp mode of the projector.
Normal: Default value. When set to normal mode, the wattage of the lamp will be at 330W. y
Eco: When set to eco mode, the wattage of the lamp will be at 280W. y
Power: Enable lamp power adjust. y
High Altitude
When “On” is selected, the fans will spin faster. This feature is useful in high altitude areas where the air is thin.
Off: Default value. y
On: Set high altitude mode on. y
Power
Set lamp power level of the projector.
Note: Power function will not be available if you have set the lamp to Eco or Normal modes.
Press the ◄ to decrease the power level. y
Press the ► to increase the power level. y
To Next Page
Loading...
