Barco UDM - Adjustment of the UST Lens

R5911438 /09 UDM72
5
5
1.5 mm
Image 5–22
5. Gently insert the lens. Ensure the lens connector matches the electrical socket on the lens holder.
6. Insert the lens until the connector seats into the socket.
Note: The secondary lens lock (ref. 2) makes an audible clicking sound when latching.
Caution: Do not release the lens yet, keep pushing the lens against the front plate!
1 3
2 4
Image 5–23 Example of mounting the UST lens
7. Secure the lens in the lens holder by sliding the primary lens lock handle into the “locked” position.
8. Check if the lens touches the front plate of the Lens Holder.
9. Check if the lens is really secured by trying to pull the lens out of the lens holder.
Image 5–24
After installation, the lens needs to be adjusted. See procedure “Adjustment of the UST lens”, page
72.
5.4.4 Adjustment of the UST lens
Because this 90 degrees lens makes use of an intermediate image in the optics of the lens, Top
becomes Bottom. For that the projector orientation settings have to be adapted accordingly: Ceiling
Mount becomes Table Mount and Front Projection becomes Rear Projection. See user manual of
the projector to modify the projector orientation.
Lenses