13 / 34 www.bartec-syscom.com
Copyright © Bartec Syscom 2019
Status LED
Green LED
ON or BLINKING
Normal operation of the device indicating that
the ROCK is active and monitoring.
OFF ROCK is switched OFF
2.4 Record LED
Refer to Figure 6. 3 LEDs are available, giving important device conditions.
Record LED
Blue LED
Always on
The ROCK is recording an event and saving
the data on the internal memory. The LED
will remain on until the end of the triggered
event, including the post-event time.
After the recording, the LED will turn off.
OFF If the ROCK is switched ON, no event is
recording
2.5 4G communication LED
Refer to Figure 6. 3 LEDs are available, giving important device conditions.
4G LED
Blue LED
Always ON
Connecting / disconnecting to the SCS.
Green LED
Always on
Connected to the SCS and transmitting the
data
OFF If the ROCK is active, no synchronization to
the SCS in process
ROCK integrates an embedded 4G LTE Cat M1 – Nb-IoT fallback 2G modem. Syscom handles the
communication between the ROCK and the SCS using an embedded SIM card.
2.6 Micro USB Connector
The micro USB connector has 3 purposes:
It is IP67 and protected by a plastic cap to avoid dust inside. Type micro USB AB.
Figure 7: USB connector
o Charging the ROCK internal battery at 5V DC
1.3A (when the Rock battery is completely empty)
using a computer or a USB charger.
o Connecting from a computer to the ROCK
Internal memory for local data transfer
and diag report recovery.
o A power bank 5V DC can also be
Connected for extended autonomy.
To Next Page
Loading...
Need help?
General
