Configuring the Camera AW00097209000
48 Basler IP Fixed Box Cameras
FTP Password - Enter a password for authentication on the FTP server. Up to 29 characters can
be used. All standard keyboard characters are valid.
Live Recording Tab
The storage requirement in the live buffer for saving pre-alarm data depends on the bitrate of the
encoder. To make sure that the live buffer is large enough for saving the determined time of pre-
alarm data, the settings of the live buffer size and the alarm buffer size for the selected stream must
be carefully tuned. Higher settings for the Pre-alarm time period [s] parameter require that the live
buffer size is also set to a higher value, which thus reduces the remaining space available for the
alarm buffer. (For information about the live buffer size and the alarm buffer size, see page 34).
Post-alarm time period [s] - Sets the amount of time in seconds that will be used for saving the
data of a live stream after an alarm has been declared. A maximum value of 60 seconds can be
entered.
The determined time of post-alarm data has only a minor impact on the storage requirement in the
live buffer. Unlike the pre-alarm data, the post-alarm data does not need to be kept temporarily in
the live buffer (see the Pre-alarm time period [s] parameter). When an alarm is declared, storing
post alarm data only requires as much memory as is needed for buffering the encoder output before
it will be saved to the SD card/FTP server.
Live Recording Behavior - Sets the behavior of the live recording alarm action.
Note that this parameter setting will only have an effect if the Live Recording parameter has one of
the values On Alarm or Alarm Recording (see page 50).
During alarm = Saving the live stream to the SD card or to an FTP server will be started if an
alarm condition has been declared and if you have checked the Action Enable box on the Live
Recording tab. Saving the live stream will be stopped as soon as the alarm condition ends.
Starting only = Saving the live stream to the SD card or to an FTP server will be started if an
alarm condition has been declared and if you have checked the Action Enable box on the Live
Recording tab. It will, however, not be stopped when the alarm condition ends.
Stopping only = Saving the live stream to the SD card or to an FTP server will be stopped if an
alarm condition ends and if you have checked the Action Enable box on the Live Recording
tab. It will, however, not be started automatically when the alarm condition is declared.
Action Enable - Check the Action Enable box on the
Live Recording tab to enable saving a live stream file to the SD card
or to an FTP server as an action to take when an alarm condition is
declared.
You can save several enabled streams to the SD card or to an FTP
server simultaneously.
Pre-alarm time period [s] - Sets the amount of time in seconds
that will be used for saving the data of a live stream before an alarm
is declared. A maximum value of 60 seconds can be entered.
To Next Page
Loading...
Need help?
General
