16-2 9492600990
Terminals and Connectors DECS-150
For more information, refer to the Power Input and Output section.
Accessory Input (I+, I–, V+, V–)
These terminals accept an external analog control signal for auxiliary control of the regulation setpoint.
For more information, refer to the Auxiliary Control section.
Contact Inputs (IN1, IN2, IN3, IN4, IN5, IN6, IN7, IN8, COM)
Programmable contact inputs 1 through 8 are applied to these inputs.
For more information, refer to the Contact Inputs and Outputs section.
Watchdog Output (WD1, WD2, WD3)
Watchdog output connections are made at these terminals.
For more information, refer to the Contact Inputs and Outputs section.
Programmable Outputs (OC1, OC2)
Programmable output connections are made at these terminals.
For more information, refer to the Contact Inputs and Outputs section.
Breaker Shunt Trip Output (ST+, ST–)
This output provides an electronic switch capable of 100 mAdc that can be used to control an external
circuit breaker.
External Tracking Inputs (GND, C2L, C2H)
A second DECS-150 connects to these terminals for the purpose of setpoint tracking.
For more information, refer to the Regulation section.
To Next Page
Loading...
Need help?
General
