Bauer LINESTAR 9000 - CHECKING OF TRUSS, END TOWER AND OVERHANG; GEARBOXES AND DRIVE MOTORS

Operating Manual for BAUER LINESTAR 9000 with hose feed 37
15.2 CHECKING OF TRUSS, END TOWER AND OVERHANG
 Are all screw connections well tightened? (Flange screws with 100 Nm)
 Are all wheel nuts well tightened? (Tightening torque 130 Nm)
 Tire pressure:
1,5 bar for tire size 14.9 – 24
2.1 bar for tire size 11.2 – 24
0.8 bar for tire size 16.9 R 24
 Are wheel gears and drive motors filled up with oil?
 Are electric cables properly fastened?
 Are cable inlets water tight?
 Are sprinklers and nozzles properly installed according to delivered computer table?
 Are all overhang ropes fastened properly?
15.3 GEARBOXES AND DRIVE MOTORS
15.3.1 GEARBOXES
Worm gear with 50:1 reduction ratio.
Model: for stationary systems
for towable systems with freely rotating hub
Used oil quality : SAE 85W-140, multigrade oil
Oil quantity approx.: 3.8 litres up to bottom edge of filling hole
oil expansion is compensated by expansion membranes
TNT Gearbox
TNT wheel gears have got two grease zerk fittings to lubricate the shifting device (cf. figure hereafter). We
therefore underline that the gears need to be lubricated before the first putting into operation of the machine as well
as once or twice per season depending on how often the machine has to change place. Use Lithium based grease
(e.g. CASTROL Grease LMX or SHELL Retinax LX2). After greasing actuate the shifting handle repeatedly to
ensure uniform spreading of grease.