Bauer LINESTAR 9000 - Page 50

42
Operating Manual for BAUER LINESTAR 9000 with hose feed
 Press „FORWARD“ key. The LINESTAR must start to move clockwise
 Press “+” key to set a high application rate
Check if the driving motor of the first tower is located in front of an assumed line connecting the drive motor of the
second tower and the middle of the central tower. If this is not the case, the alignment control on the first tower
must be readjusted as follows: Unwind the hexagonal nuts and twist the threaded rod until the above requirement
is fulfilled.
The next step is to check if the drive motor of the second tower is positioned in front of an assumed line
connecting the drive motor of the third tower and the middle of the central tower. If this is not the case, correct the
alignment control on the second tower.
Now check all the towers step by step as described under a) and b) Re-adjust alignment controls if necessary.
Finally the LINESTAR should form a positive bow, which means that the towers in between end tower and central
tower must be positioned in front of an assumed line between end tower and central tower.
 Press „STOP“ key
 Turn main switch to position „0“