– 18 –
Clearing All Recipes
1. Switch the oven into the OFF mode.
2. Press and hold the Recipe down button then press and hold the POWER ON OFF button until you
hear a single short beep and followed by a longer beep. This long beep indicates that the recipes
have been cleared.
Loading Recipes via USB Flash Drive
1. Switch the oven into the OFF mode.
2. Insert the ash drive that contains the recipe binary
le [RECIPE.BIN] into the USB socket.
3. Press and hold the STOP button then press and
hold the POWER ON OFF button, keep holding both
buttons until the word ‘UPdt’ [Update] is displayed
in the clock eld.
Once the recipe le has been imported into the oven
successfully, the display will show ‘rebooting’ for a few
seconds and the oven controller will reboot.
If there are any errors reading or programming the recipe
le into the oven, the error will be displayed and the
oven will not reboot. You will need to power off the oven,
wait 10 seconds, and then power on the oven to make it
operable again.
If no binary le, Firmware or Recipe, is found the display will show:
‘UPdt-FAIL-USb-Err’ [Update fail USB error]
To correct this error, insert the correct USB drive and power off and then power on the oven.
To Next Page
Loading...
Need help?
General
