EasyManuals Logo

baxter ML-132577 User Manual

baxter ML-132577
36 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #28 background imageLoading...
Page #28 background image
– 28 –
OWNER PREVENTIVE MAINTENANCE PROCEDURE
INTRODUCTION
This customer PM section includes procedures to inspect for proper operation and cleaning of components.
Owner Preventive Maintenance Procedures are written for gas ovens. They can also be used for electric
ovens by omitting the steps that refer to components found only on gas ovens. To maintain the safety and
performance of bakery ovens, a program of scheduled periodic maintenance must be implemented. It is
the sole responsibility of the user to establish, schedule, and enforce such a program. Although the service
interval will vary depending on the environment in which the equipment is operating, it is recommended
that PM be performed and all safety devices are checked at a minimum of 12-month intervals. Check with
the authority having local jurisdiction if there are specic maintenance requirements specied by local,
state, or national codes. A convenient PM Checklist is provided at the end of this section.
NOTE: This PM procedure does not discuss repair or replacement of components. Upon completion of
the PM procedure, you will need to contact a qualied servicer for any needed repairs.
Tools Used for Inspection Procedure
Standard set of hand tools
Vacuum cleaner - shop vac
PREVENTIVE MAINTENANCE PROCEDURE
Disconnect the electrical power from the machine and follow lockout / tagout
procedures. There may be multiple circuits. Be sure all circuits are disconnected.
Shut o󰀨 the gas before servicing the unit.
Certain procedures in this section may require electrical test or measurements
while power is applied to the machine. Exercise extreme caution at all times. If test points are not
easily accessible, disconnect power and follow lockout/tagout procedures, attach test equipment,
and reapply power to test.
Inspect Oven Lamps
1. Lamps should be on when oven is powered.
2. If not, replace lamps (Fig. 44).
A. Remove lens cover by turning out of lamp
housing.
B. Remove oven lamp by turning lamp out of
lamp socket.
3. Reverse the procedure to install new lamps.
Fig. 44
Lamps

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the baxter ML-132577 and is the answer not in the manual?

baxter ML-132577 Specifications

General IconGeneral
Brandbaxter
ModelML-132577
CategoryOven
LanguageEnglish

Related product manuals