baxter ML-132577 User Manual

– 30 –
Inspect Door Components
1. Check loading door latch.
A. Check door gasket for good condition. If door gasket
needs replacement, contact your local Baxter authorized
service o󰀩ce.
B. Check that the loading door lock ramps are clean (Fig.
48) and rollers on the door move up and down and spin
freely (Fig. 49).
C. Adjust latch ramps in or out by loosening the
two screws. DO NOT REMOVE THEM.
Slide ramp in or out to loosen or tighten
door (Fig. 48).
D. Tighten screws.
2. Check door sweep.
A. The door sweep should hit the oor evenly across door
width when door is in the closed position.
B. Turn oven on.
C. If air (or steam) blows out from underneath the door, door
will need to be adjusted. If door sweep needs replacement
or adjustment, contact your local Baxter authorized
service o󰀩ce.
3. Check interior door release (Fig. 50) for proper operation.
4. Check door switch for proper operation.
A. When door switch actuator rod is in the open position
(door open), the door switch rollers should be positioned
on the small part of the rod (Fig. 51).
Fig. 48
Door Lock Ramp
Fig. 49
Door Roller
Fig. 50
Interior Door Release
Fig. 51
Rod
Bracket
Door Switch Rollers

baxter ML-132577 Specifications

General

Brand	baxter
Model	ML-132577
Category	Oven
Language	English