12
AXE MASTER SETUP
Locate the 2 of short metal connector plates.
(Label C) (Part # A5ME29013)
A5BOPH312
Prep right side cage for installation.
Locate right side cage assembly - (Labeled 2)
Part # AAME29000-R The LED light must point
toward the rear of the cabinet.
Locate right upper cage support wood - (Labeled N)
Part # WACA29043 Ensure it has the “R” etched in
the middle of the wood.
Place the wood piece (N) on top of the cage piece (2)
The R mark must be on the inside of the cage.
The LED light stick will be on the inside pointing toward the
back of the game.
Install a short metal connector plate at the top left and right edge of
the wood piece as shown.
4 of the black ¼-20 X 1 Phillips head bolts using a # 3 Phillips Head
bit.
2 per bracket.
Using the same process as the other side, secure the right wood to the top of the
right cage using 6 of the black 10 X 5/8” screws using a # 2 Square Head bit.
3 screws per bracket.
A5SCPH152
Right end
of wood
Left end of
wood
2
N
C
To Next Page
Loading...
