29
CARD SYSTEM SETUP
There are many different card systems that the Prize
Hub supports. The installation is similar, but write
down and double check settings.
Specific systems will be discussed on the following
pages.
If problems arise, more detailed instructions will be
provided in the Troubleshooting section.
Plug in an Ethernet cable to the port shown on the
main board (inside the Main Hub), and out through
the hole in the bottom of the cabinet.
Mount your card reader according to manufacturer
instructions, and plug the Ethernet cable into your
card reader server.
Adjust the Kiosk Interface in the location menu.
Enter Network Setup Menu
Please leave the Prize Hub Network disabled.
Set the Card Server (This is IP address of your serv-
er) and Port number.
Note: It is important to note if the IP address has a
leading 0 in the octet.
So in this example:
064.126.017.030 is NOT the same as 64.126.17.30
Please be aware and type it in the Prize Hub exactly
as you are given by the card swipe company.
If required, set username and password for your
specific card system network.
To Next Page
Loading...
Need help?
General