35
Plug in an Ethernet cable to the port shown on the main board (inside the
Main Hub), and out through the hole in the bottom of the cabinet.
Mount your card reader according to manufacturer instructions, and plug the
Ethernet cable into your card reader server.
Adjust the Kiosk Interface in the location menu to show “Sacoa”
Enter Network Setup Menu
Please leave the Prize Hub Network disabled.
Set the Card Server. This is IP address of your server. It should be in a similar
format as shown.
Set Port number. This is the port number of your server. It should be in a
similar format as shown.
If required, set username and password for your specific card system network
Call Sacoa to get this information.
Note: It is important to note if the IP address has a leading 0 in the octet.
So in this example:
064.126.017.030 is NOT the same as 64.126.17.30
Please be aware and type it in the Prize Hub exactly as you are given by the card swipe company.
SACOA OPTION
Part # AAKIT-PH-READER
Plug in an Ethernet cable to the port shown on the main board (inside the
Main Hub), and out through the hole in the bottom of the cabinet.
Mount your card reader according to manufacturer instructions, and plug the
Ethernet cable into your card reader server.
Adjust the Kiosk Interface in the location menu to show “Ideal”
Enter Network Setup Menu
Please leave the Prize Hub Network disabled.
Set the Card Server. This is IP address of your server. It should be in a
similar format as shown.
Set Port number. This is the port number of your server. It should be in a
similar format as shown.
If required, set username and password for your specific card system net-
work.
Call Ideal to get this information.
Note: It is important to note if the IP address has a leading 0 in the octet.
So in this example:
064.126.017.030 is NOT the same as 64.126.17.30
Please be aware and type it in the Prize Hub exactly as you are given by the card swipe company.
IDEAL OPTION
Part # AAKIT-PH-READER
To Next Page
Loading...
Need help?
General