1705Router Web Configuration Manual
Secondary IP address, subnet mask: fill in the IP address and subnet mask.
Note:
If the system shows the following information:
It is warning: you are configuring the router through this port, and you couldn’t alter this IP address. If you
click “apply” button to alter this IP address, system will disconnect with Web and you will not configure the
router.
1.4.3 NAT Configuration
What is called NAT, that is Network Address Translation. Its essence is that alter the
source IP address of data-packets which pass through router, in order to make more
users share one public ip address, or open Web service and FTP service in LAN.
The configuration page layout is following:
There are two parts:
Connection Settings:
Max-entries: The value is used to set the max-entries for NAT mapping. ( In
order to prevent virus, usually the value is 300. It depend on using situation
- 11 -
To Next Page
Loading...