1705Router Web Configuration Manual
Chapter 1 The use of CMS
Before configuring the router, please ensure that your computer is installed necessary
softwares(for example: Windows 95/98/ME/NT2000/XP), and configure the netwok in
reason. If you don’t know how to configure network, please read the setting explanation
of next section ”Configure network”. If you have already configured network correctly,
you can leap over next section and refer to “Configuration guide” directly.
Note:
1) This configuration method(configure router by Web page layout) is suitable for primary technical
personnel, but we recommend telnet mode to configure router for intermediate or senior technical
personnel. You should avoid by all means using web and telnet at one time to config router.
2) When you use web to config 1705, You should renovate the page layout after configuring 1705
completely in order to show the correct result.
3) If you use web to config 1705, we suggest that you ues Microsoft IE browser 6.0 or high-edition,
and use 1024*768 screen area.
1.1 The network setting
The default interface of 1705 is TP2, and the default IP address of TP2 is 192.168.2.1,
the default subnet mask is 255.255.255.0. These parameters can be altered for need,
and they are default value in the following character. The material step for setting
network is shown as following (take example for Windows 2000):
Step 1: Connect your computer to the fast Ethernet port TP2 of 1705 router.
Step 2: Setting the IP address of this computer.
(1) Beginning
－
>control panel
－
>network and dialing connection
(2) Use the right key to click”network connections”, then click”property”menu.
(3) Pitch on”Internet protocol(TCP/IP)”. The figure is following:
- 1 -
To Next Page
Loading...