30
NAVIGATION MODE >>>
> EN
Route planning
The route planning menu allows you to
create and select individual routes. To do
this, enter the individual destination
points for the desired route. It is then pos-
sible to travel to these points consecutively
without having to enter any further infor-
mation. You can also optimise the desti-
nation points entered and in so doing
change their order.
> Select
Route planning from the desti-
nation input menu.
The route menu is displayed.
In the route menu, you can create a new
route by selecting
Create new route. In
the list displayed below, the stored previ-
ous routes are displayed in alphabetical or-
der.
Editing stored routes
You can change the name of a stored route
or delete it.
> Highlight the route you wish to edit.
> Push the rotary control/push button to
the right.
By selecting
Rename route you can give
the route a new name.
By selecting
Delete route you can delete
the route from the stored routes.
Selecting and starting a route
> Select the required route from the route
menu.
The route is loaded and displayed in the
stage menu.
> Select
Calculate.
> Select the start point or your current
position as the start point for route
guidance.
The individual stages are calculated.
A map of the stages will then be displayed.
The total distance and estimated total
journey time are displayed on the left-
hand side.
> Select
Start to start route guidance or
select one of the functions described be-
low.
Note:
If no routes have yet been stored, the
route menu is empty.
Note:
You can also select a stage in the route
here. The route is then started from this
stage.
Note:
When a start point is selected, this is only
used for the purposes of displaying a
route.
To Next Page
Loading...
Need help?
General
