Behringer DEEPMIND 12 - Polyphony and Program Help

120 DeepMind 12 User Manual
10.8 Polyphony
To change the POLYPHONY, press and hold the UNISON DETUNE EDIT switch. While
holding the switch, you can then adjust the UNISON DETUNE fader to select the
POLYPHONY from the available options. The following message will be shown to
give you guidance while holding the UNISON DETUNE EDIT switch.
10.9 Program Help
To access the program browser, press and hold the PROG switch.
The PROG HELD help will appear while the PROG switch is held, showing
additional guidance and commands. See section 4 for more details on these
program shortcuts.
Here is an overview of the options:
• To browse the available programs: With the PROG switch held down, press
the GLOBAL switch or turn the Rotary control to browse the list of programs.
Press PROG again, and the currently highlighted program in the list will
become the current program.
• To show a list of favorites: With the PROG switch held down, press the FX
switch and turn the Rotary control.
• To add the current program to the favorites list: With the PROG switch held
down, press the FX switch and press the +/YES switch. A small happy face
will appear in top right of the display of that program. Press -/NO to delete
the program from the favorites.
• To delete all favorites: With the PROG switch held down, press the FX switch
and press the WRITE switch. The conrm using +/YES and the favorites list
will be emptied. (No programs are lost.)
• To change the current program to others in the same category : With the
PROG switch held down, press the -/NO/+/YES switches to select the
PREVIOUS/NEXT programs within the same category as the current program.
• To change to a dierent category: With the PROG switch held down, press
the BANK/UP, BANK/DOWN switches to select the PREVIOUS/NEXT category.
• When you load a program, all the physical controls on the DeepMind 12 may
not match the position stored in memory. In order to send all the physical
positions to the program (rather than moving each individually until you
reach the stored value), follow this procedure: With the PROG switch held
down, press the WRITE switch. The current program will then be updated
with the positions of the physical controls on the DeepMind 12.
• In order to return to a xed point when creating programs, you can recall a
default program that is congured without modulation or eects, and uses
basic settings in each of the sections. To load the default program: With the
PROG switch held down, press the COMPARE switch. The default program
will then be loaded and the program name will change.
10.10 Poly Chord
To access the poly chord WIZARD quickly, press the POLY CHORD switch, then
press and hold any note on the keyboard, and use the rotary control to cycle
through the available chords. Use the BANK/DOWN and BANK/UP switches to
select other MOD options. See section 8 for more details.