60 DeepMind 12 User Manual
8.2.2 LFO DELAY TIME FADER
• The DELAY TIME fader controls the amount of delay before the LFO starts.
When the LFO waveform starts, it is faded-in over a period of time. If you
think of the time to reach the full LFO waveform as 100%, then 40% of that
time is used for the delay period where no waveform is produced, and 60%
of that time is used for the fade duration.
The DELAY TIME range is from 0.00s to 6.59s, and the default value is 0.00s.
The fader position, current value, and stored value for the LFO DELAY TIME
fader is shown on the PROG screen. There is also a visualization of the
waveform as shown below:
NONE
MED
NO LFO FADE IN
NO LFO FADE IN
SLOW
LFO DELAY TIME
8.2.3 LFO WAVEFORMS INDICATORS
• The LFO waveform shape setting is always shown on the LEDs.
The LFO waveform shape in use will have an illuminated LED next to it.
The LED will glow to show the status of the waveform as shown below:
8.2.4 LFO EDIT MENU
1. To access the LFO EDIT menu, press the LFO EDIT switch.
Shortcut Note: To quickly change the LFO waveform shape, press and hold
the LFO EDIT switch, and move the LFO RATE fader.
2. Press the LFO EDIT switch once, and it will then start ashing as a reminder
you are in LFO EDIT mode. The LFO EDIT menu will appear:
3. To navigate the options in the LFO EDIT menu, use the BANK/UP, and BANK/
DOWN switches to the right of the display.
FULL BRIGHTNESS
HALF BRIGHTNESS
OFF
LFO WAVEFORM INDICATORS
FLASHING=EDIT
To Next Page
Loading...
Need help?
General
