Behringer DEEPMIND 12 - Page 23

23 DeepMind 12 User Manual
7.2 .3 SELECTING FX MODE
1. To select an eects MODE, make sure that the '<' symbol is highlighted next
to the eects MODE symbol, then you can either turn the rotary knob, or use
the data entry fader to select from one of the following routings.
INSERT - In this conguration the eects slots are placed as INSERT eects
into the signal ow of the synthesizer outputs.
SEND - In this conguration the synthesizer output signals are SENT to the
eects slots and the returned into the signal ow of the synthesizer outputs.
BYPASS - In this conguration the eects are bypassed.
7.2 .4 SELECTING FX
1. To load an eect into a slot, make sure that the '<' symbol is highlighted
next to the slot you wish to use. Then you can either turn the rotary knob, or
use the data entry fader to select from one of the following eects:
2.
No Name Type
1 TC-DeepVRB Reverb
2 AmbVerb Reverb
3 Room Rev Reverb
4 VintageRev Reverb
5 Hall Rev Reverb
6 Chamber Rev Reverb
7 Plate Rev Reverb
8 Rich Plate Reverb
9 Gated Rev Reverb
10 Reverse Rev Reverb
11 ChorusVerb Reverb
12 DelayVerb Reverb
13 FlangeVerb Reverb
14 Midas EQ Processing
15 Enhancer Processing
16 FairComp Processing
17 MulBndDist Processing
18 RackAmp Processing
19 EdisonEX1 Processing
20 Auto-Pan Processing
21 NoiseGate Processing
22 Delay Delay
23 3TapDelay Delay
24 4TapDelay Delay
25 T-RayDelay Delay
26 DecimDelay Delay
27 ModDlyRev Delay
28 Chorus Creative
29 Chorus-D Creative
30 Flanger Creative
31 Phaser Creative
32 MoodFilter Creative
33 DualPitch Creative
34 Vintage Pitch Creative
35 RotarySpkr Creative
When you stop on an eect, it is automatically loaded into the chosen slot.
7.2 .5 CONTROLLING MIX / LEVEL
1. To adjust the MIX parameters make sure that the '<' symbol is highlighted
next to the word MIX on the eect slot you want to adjust. Then you can
either turn the rotary knob, or use the data entry fader to change the value.
7.2 .6 CONTROLLING LEVEL
1. To adjust the LEVEL parameters, make sure that the '<' symbol is highlighted
next to the word LEVEL on the eect slot you want to adjust. Then you can
either turn the rotary knob, or use the data entry fader to change the value.
Note: The MIX parameter is not used on eects which are marked as
"Processing" types in the Eects List. Also, be aware that the MIX parameter
seen on the FX OVERVIEW, and the MIX parameter shown in the FX
editing pages, are the same parameter and are shown in both pages for
convenience.
2. If the MIX parameter or the LEVEL parameter are not available, you will see
the "--" symbols in the FX OVERVIEW screen.