Behringer DEEPMIND 12 - Page 25

25 DeepMind 12 User Manual
7.2 .10 MOVING EFFECTS
If you need to move an eect to a dierent slot, please follow this procedure:
1. Ensure you have saved any edits you have made to your current program if
required.
2. Press the FX switch to enter the FX OVERVIEW page.
3. Navigate to the eects slot you wish to move.
4. Press and hold the FX switch until you see the following message and the
BANK/UP, BANK/DOWN switches begin ashing:
5. While continuing to hold the FX switch, you can move the eects slot to
another location using one of these methods:
6. To move the slot to an adjacent upper slot press the BANK/UP switch.
7. To move the slot to an adjacent lower slot press the BANK/DOWN switch.
8. To move the slot to any other slot, turn the rotary knob.
9. You can continue to move the slot with any of the methods above, the new
slot will be highlighted as shown below:
10. Once you release the FX switch, the eect will be moved to the new slot.
Note: All eects parameters will be moved with the eect.