41 DeepMind 12 User Manual
CHORD SCREEN SOFT KEYS - At the bottom of the chord screen are 3 labels
which indicate the software function of the illuminated PROG, GLOBAL and
WRITE switches. If no previous chord is present, the display will show the status
of the chord programming function, for example: ARMED, LEARNING, or PRESS
TRIGGER, as explained later.
• PROG switch - Performs the EXIT function and returns to the PROG screen.
• GLOBAL switch - Used to RECORD a new chord over an existing chord.
• WRITE switch - Used to DELETE the chord, but only once a chord is
programmed (otherwise this area will be blank and the WRITE switch will
not be illuminated)
Note: The chord is stored in persistent memory and will be retained through a
power cycle. Only one chord is created and stored at a time.
Note: The chord memory can also be cleared using the "bootloader" menu
described later in this document.
Note: The chord size is limited to 12 notes.
CHORD PROGRAMMING
1. To program a chord, rst press the CHORD switch. If there is no previous
chord in memory, the CHORD switch will begin double ashing and the
message "ARMED" will appear in the display as shown:
2. Play the desired chord, and "LEARNING" will appear in the display as shown:
3. You can add additional notes to the chord as long as at least one note is still
being held down. Release all the keys when you are done.
2X FLASHING FAST
4. The status line shows the text "CUSTOM-TYPE-NOTES" where:
• CUSTOM - indicates this is a chord you have created.
• TYPE - If the chord type is recognized as one that is saved in the WIZARD
memory (described in the Poly Chord section later), then the chord TYPE
is displayed. For example, the chord shown above is TYPE = Ma.
• NOTES - The component notes of the chord.
5. You will now be asked to assign the chord to a trigger key: “PRESS TRIGGER”
will appear in the display as shown:
6. Press any key on your keyboard, and the screen will change to show the
details of your new custom chord in the status line. The example below is a
Major chord (Ma) with the trigger C4, and notes C4, E4, and G4.
• PLAYING THE CHORD - While the CHORD switch is still illuminated, press
any key on the keyboard to play the chord you just programmed. The chord
will be transposed from the root note to every key that you play.
• RECORDING A NEW CHORD - While you are still in the chord mode (the
CHORD switch is still illuminated), you can record a new chord and overwrite
the existing chord, by pressing the REC soft switch. The existing chord will
be deleted and "ARMED" will appear again, allowing you to program a new
chord as before.
• DELETING THE CHORD - To delete the chord, press the DEL soft switch.
The chord will be deleted and "ARMED" will appear again, allowing you to
program a new chord as before.
FLASHING SLOW
ILLUMINATED
2X FLASHING FAST
To Next Page
Loading...
