54 DeepMind 12 User Manual
(7) SAVE/IMPORT -This switch allows you to SAVE the current PATTERN, or
IMPORT a PATTERN. When you press the WRITE switch (under the SAVE/
IMPORT text) you will be presented with two options:
You can now use the -/NO and +/YES switches to select SAVE or IMPORT, or
press the EDIT ARP/SEQ switch to exit the dialog. All three switches will ash
to show that they are the available options:
• SAVE - This will save your edits into the currently selected location. This
will overwrite the user PATTERN stored in the current location.
Note: You can only SAVE into USER PATTERN locations, as the PRESET
PATTERNS are protected.
• IMPORT - Selecting IMPORT will open a read only version of the
PATTERN EDITOR page, so that you can preview the pattern which will
be imported into the current location. Parameters cannot be edited in
this page.
To select a PATTERN to IMPORT, use the -/NO and +/YES switches to
move through all the factory and user presets. To IMPORT the desired
PATTERN, press the WRITE switch (under the IMPORT text), and the
pattern will appear in your current user preset.
BACK - This will cancel the SAVE/IMPORT function and return you to the
PATTERN EDITOR.
Note: The SAVE/IMPORT switch is only available when a USER PATTERN
is selected.
Note: After IMPORTING a preset, the new changes still need to be
saved, as shown below:
NO=SAVE
YES=IMPORT
EDIT=CANCEL
Note: If you have edited a PATTERN or IMPORTED a new one, and then go to
select another PATTERN without saving your changes, you will be presented
with a warning message that unsaved edits will be lost. You can press +/YES
to allow the change, or -/NO to cancel the change.
To exit the PATTERN page, press the EDIT switch in the ARP/SEQ section and
return to the main ARPEGGIATOR menu.
To exit this menu and return to normal operation, press the EDIT switch 3
more times, or press the PROG switch, until you see the main PROG display.
To Next Page
Loading...
