Behringer DEEPMIND 12 - Page 88

88 DeepMind 12 User Manual
8.7 HPF
The HIGH PASS FILTER (HPF) is applied to the output of the VCA. Because the VCA
sums all the voices, the HPF will aect all voices simultaneously.
8.7.1 HPF FREQ FADER
• The HPF FREQ fader controls the cut-o frequency of the HPF. The HPF will
begin cutting frequencies above the cut-o frequency and continue to cut
them at a xed rate of -6 dB per octave.
The HPF lter can be useful in removing subsonic frequencies from
your sound if required. You can also use this lter to sculpt the sonic
characteristics of the program, or you can dynamically adjust the fader to
create sweeps of the lter which will create distinctive movement.
The HPF Frequency is available in the Mod Matrix as a destination, where it
can be modulated from any of the Mod Matrix sources.
The HPF FREQ range is from 20.0 Hz to 2000.0 Hz, and the default setting is
20.0 Hz (fully open).
The fader position, current value, and stored value for the HPF FREQ fader is
shown on the PROG screen. There is also a visualization of the lter curve as
shown below.
LEVEL (dB)
FREQUENCY (Hz)
LOW
SAWTOOTH SQUARE
MED
HIGH
HPF FREQUENCY
LEVEL (dB)
FREQUENCY (Hz)
LEVEL (dB)
FREQUENCY (Hz)
8.7.2 BOOST SWITCH
• This switch controls the BOOST stage of the DeepMind 12.
The boost function enables an analog circuit which is designed to boost
low frequencies at 100 Hz using a shelving equalization and DC blocking
functionality.
The BOOST function can be used to give programs an enhanced low
frequency response resulting in more depth and body.
The BOOST function can be On/O, and the default program setting is O.
There is also a visualization of the BOOST lter curve on the PROG screen as
shown below.
Note: You will only see the BOOST visualization if the HPF fader was the last
fader that was moved.
ON=BASS BOOST
BOOST RESPONSE
LEVEL (dB)
100 Hz
0 dB
6 dB
FREQUENCY (Hz)