Behringer DEEPMIND 12 - Page 91

91 DeepMind 12 User Manual
8.8.4 CURVES SWITCH
This switch changes the operation of the ADSR faders from adjusting the ADSR
stages to adjusting the curve of each stage.
1. Press the VCA, VCF, or MOD switch to choose the envelope whose curves you
wish to modify.
2. Then activate CURVES mode, by pressing the CURVES switch. The switch will
illuminate and the A,D,S, and R faders will now control the curve of each
stage.
• CURV ATK: This controls the curve shape of the attack stage.
• CURV DCY: This controls the curve shape of the decay stage.
• CURV SUS: This controls the curve shape (or slope) of the sustain stage.
• CURV REL: This controls the curve shape of the release stage.
Using the curve functionality of the waveforms allows advanced sculpting of
any of the envelopes. An example is shown below:
Note: When you adjust any of the envelope faders while viewing the PROG
screen, you will see a visualization of the envelope. Below the visualization
you will see the standard or curve parameter values as shown below:
ON=CURVES
ATTACK
CURVE
DECAY
CURVE
SUSTAIN
CURVE(SLOPE)
RELEASE
CURVE
ENVELOPE CURVES
3. To return to normal operation of the ADSR stages, press the CURVES switch
again. The CURVES switch will no longer illuminate, and the faders will now
control the ADSR stages of whichever envelope switch is currently on: VCF,
VCF, or MOD.
Note: The curve values and the respective response curves are shown below
for guidance:
0
64
128
192
255
Attack Curve Settings
Time
Level
Time
0
64
128
192
255
Decay/Release Curve Settings
Level
Time
0
64
128
192
255
Sustain Curve (Slope) Settings
Level