Behringer WAVE - Top Panel; Master Controls; Low Frequency Oscillator; Envelope Generator 1

16 WAVE User Manual
Top Panel
The following sections describe the top panel controls of the Wave; and how they
are used in program creation. All Top Panel control settings are stored in the
program memories, with the exception of Basis
(1 )
and Master Volume
(2)
.
The control settings can be monitored and ne adjusted if needs be in the
Analog Menu, described below.
Master Controls
1
2
(1) Basis – adjusts the stereo spread of the notes played on the keyboard.
When the control is at minimum then all notes will be output at equal level
from both the channel 1 and channel 2 outputs. When the control is at
maximum notes will alternate between the outputs.
(2) Master Volume – sets the Wave's output level.
Low Frequency Oscillator
3 4 5
(3) LFO Delay – delays the action of the LFO. When the control is at minimum
there will be a slight delay before modulation can be heard (depending on
the rmware setting (see User Menu below)). When at maximum there will
be a delay of 10 seconds before modulation is applied.
(4) Waveshape – the LFO has four waveshapes available: triangle, ramp,
sawtooth and square.
(5) Rate – controls the rate at which the LFO runs, from 0.2 Hz to 12.0 Hz.
Envelope Generator 1
6 7 8 9
(6) EG 1 Attack – controls the attack time for the lter envelope. If the
Envelope attack rate is set above 47 then the attack will fully complete even
if the key is released; and will then move to the release phase. This can be
used for lter and wavetable sweeps.
(7) EG 1 Decay – controls the decay time for the lter envelope.
(8) EG 1 Sustain – controls the sustain level for the lter envelope following Decay.
(9) EG 1 Release – controls the release time for the lter envelope.