Behringer WAVE - Envelope Generator 3; Envelope Generator 2; Group; Modifiers Control

18 WAVE User Manual
Envelope Generator 3
14 15 16
(14) EG3 Attack – controls the attack time for the third envelope.
(15) EG3 Decay – controls the decay time for the third envelope.
(16) EG3 Attenuation – attenuates (reduces) the maximum output of the third
envelope generator. This has a dierent eect according to what the third
envelope is being used for: if it is being used on the pitch of the oscillator
then in position ve there is no modulation, with lower settings resulting
in negative action and higher in positive. When used for modulating the
wavetables then the settings run from no modulation at 0 to full
(63 wavetable steps) at 10. This modulation is added to the WAVES SUB value.
Envelope Generator 2
17 18 19 20
(17) EG 2 Attack – controls the attack time for the loudness envelope. If the
Envelope attack rate is set above 47 then the attack will fully complete even
if the key is released; and will then move to the release phase. This can be
used for lter and wavetable sweeps.
(18) EG 2 Decay – controls the decay time for the loudness envelope.
(19) EG 2 Sustain – controls the sustain level for the loudness envelope
following Decay.
(20) EG 2 Release – controls the release time for the loudness envelope.
Loudness modulation
Loudness can be modulated by the following sources:
• • LFO (Option ML in Digital menu)
• • Keyboard (Option KL in Digital menu)
• • Velocity (Option VL in Digital menu)
• • Aftertouch (Option TL in Digital menu)
• • Expression pedal (Option EXP-PED in USER menu)
• • Envelope 2 (Default)
ENV2
ENV2>LOUDNESS
ML:1
LFO
TL:1*
+
+
KL:0-7
VL:1-3
EXP-PED:1
LOUDNESS
MOD Wheel
+
EXP-PED:5
velocity sensor
* TOUCH has bo ne enabled in the USER menu.
Note that the ML option set to 1 switches on direct modulation through the LFO if
FIRM is 0. When FIRM is set to 1, then the amount of LFO loudness modulation is
determined by the Mod wheel. See User Menu and Digital Menu sections below.
Group
21
(21) Group – each program has two sounds associated with it, in groups A and B.
The group LEDs indicate which sound can be edited when using the DIGITAL/
TUNING/ANALOG menus. If both LEDs are lit, parameter changes eect both
group sounds. In KEYB POLY 8x1 mode, the lit LED indicates which sound is
used. (if both LEDs are lit, group B sound is used).
Modifiers Control
22 23 24
(22) Env 1 VCF – controls the amount of lter modulation from Envelope Generator 1.
(23) Env 2 Loudness – this control adjusts the output level of the active group;
and can be used to balance group A and B sounds when used together or in a
split mode.
(24) Env 1 Waves – controls the use of Envelope Generator 1 to step through
the waveforms in the wavetable in use. If a transient is selected then
this control will set the loop point for sample playback for both the main
oscillator and the sub-oscillator.