Behringer WAVE - Menus; Program Menu

20 WAVE User Manual
Main and Sub Oscillator Modulation
Both the Main and Sub oscillators' pitch can be modulated by the following sources:
• • Pitch bend (Option BD in Digital menu)
• • LFO (Option MO and SO in Tuning menu, through the MOD wheel)
• • Expression pedal (Option EXP-PED:5 in USER menu, through the LFO if
MO/SO is activated)
• • Envelope 3 (Option EO and ES in Tuning menu)
Note: Bend Interval (BI) in Digital menu determines amount of Pitch Wheel
modulation. EO2 - 9 in TUNING menu activates polyphonic portamento.
(40) Modulation Wheel – can be used for various types of modulation
depending on the user settings. Please note that the wheel position is stored
in each preset, separate for Group A and B sound parameters.
(41) Octave Up/Down – transposes the keyboard up by one octave or down by
one or two octaves, as indicated by the associated LEDs.
Menus
Program Menu
This is the default menu, which you will see on the display when you power up. It
indicates the status of the Wave.
Please note that where two characters are required on a data entry then a
leading zero should be added for single gure numbers (eg 01 for 1.) Parameters
are navigated using the left and right cursor controls on the numeric keypad
(28)
;
or by using the data encoder
(25)
.
From left to right / top row:
PROG – indicates the current program number from 0 to 99.
BANK – indicates the program bank in use, 0 or 1.
WAVE/TRAN – indicates the wavetable or transient associated with the current
program, from 0 to 127. Positions 0 to 30 are the preset wavetables, position
31 is a preset transient wave, positions 32 to 63 are user dened transients and
positions 64 to 127 are user dened wavetables.
MIDI – indicates the MIDI transmit and receive channel that your Wave is set to.
0 – indicates that MIDI is switched o; no messages will be transmitted
or received.
1-16 – indicates that the Wave will transmit and receive on the specied
channel (MIDI mode 3).
DTF – indicates Data Transfer status as follows:
0. Program (default)
1. A – A, B – B: the program data for the group A sound is loaded into
the group A edit buer, and that of group B to the group B edit buer.
Wavetable, split and keyboard mode are unaected.
2. A – A: the program data for the group A sound is loaded into the
group A edit buer. Group B, wavetable, split and keyboard mode are
unaected.
3. B – B: the program data for the group B sound is loaded into the
group B edit buer. Group A, wavetable, split and keyboard mode
are unaected.
4. A – B: the program data for the group A sound is loaded into the group B
edit buer. Group A, wavetable, split and keyboard mode are unaected.
5. B – A: the program data for the group B sound is loaded into the group A
edit buer. Group B, wavetable, split and keyboard mode are unaected.
6. A – A & B: the program data for the group A sound is loaded into both
edit buers. Wavetable, split and keyboard mode are unaected.
7. B – A & B: the program data for the group B sound is loaded into both
edit buers. Wavetable, split and keyboard mode are unaected.
8. INIT: this option resets the Wave to its factory settings. You will be
asked to type 1 to conrm reset or 0 to cancel.
9. Store