Behringer WAVE - Troubleshooting

40 WAVE User Manual
Troubleshooting
Q1. Voices are out of tune.
• • Check if any of the SEMIT and/or DETU settings in the Tuning menu are
enabled. Make sure global TUNE is set to 440 in the Program menu.
• • Perform VCA and VCF calibration. For more information about how to
perform calibration please refer to the calibration section above.
• • Check MO, SO, EO, ES settings in the Digital menu.
Q2. The synth does not generate any sound.
• • Check that output audio is connected to your sound system.
• • Check that the master volume control
(1)
is above minimum level.
• • Check that LOC is enabled in the Program menu.
• • Make sure ENV1->Loudness is not set to Zero.
Q3. After touch does not work
• • Check that TOUCH parameter in User menu is correctly congured.
• • Check whether the other modulation sources are maximising the modulation.
• • If you are using an external keyboard, check that it is transmitting on the
right MIDI channel.
Q4. Wave does not respond to external MIDI.
• • Verify that your midi source is correctly connected to Wave (MIDI DIN or USB)
and that you are transmitting on the right MIDI channel. You can change the
Wave MIDI channel from the Program menu (MIDI: --).
• • If CC messages are involved, please verify that the PARAM settings in User
menu are correctly congured.
Q5. Wave does not send MIDI data
• • Check that Wave is connected to destination MIDI device.
• • Check that the Wave MIDI channel corresponds to the destination
MIDI channel.
• • If CC messages are involved, please verify that the PARAM settings in the
User menu are correctly congured.
Q5. Some of the modulation sources in the Digital menu do not aect the sound.
• • In the WAVE some modulation sources can be summed up. This means that
if the modulation limit is reached, any additional modulation will not have
any eect.
Q6. Sequencer / Arpeggiator do not start when connected to external sequencer
• • Make sure sequence is stored
• • Check that Wave is connected to external device and MIDI channel is correct
• • Check that input source is correctly congured in the Sequencer
menu (CLK: --)
Q7. CV IN does not work properly.
• • If notes are out of tune, perform CV Input calibration.
• • Make sure Gate signal is connected to WAVE and your source device is
transmitting the signals.
• • Make sure your external device is working correctly.
Q8. SynthTribe (or other apps) do not detect the Wave over USB
• • Try a dierent USB lead, especially if you are using a long one.
• • If you are using a USB hub try bypassing it by making a direct connection
between your computer and the Wave.
Q9. SynthTribe is unable to communicate with the Wave
• • Check that the SYSEX parameter in the Program menu is set to 1.
Q10. Some notes in the upper octaves produce no sound
• • Check if there is a large SEMIT detuning in place in the Tuning menu.
Large SEMIT detunes can take the Wave above its MIDI note limit.