GB Double Sound Speed Controller SFR-1-D
01.03.2020 BEIER-Electronic 43
Input „cannon shot“
At output X15/1 and X15/2 a „cannon shot“ can be activated. If X15/1 and X15/2 are
connected with a switch contact, a cannon shot is started. A cannon shot has three
parts:
• Additional sound „Cannon shot“
• Xenon flasher at X15
• IR shot with the battle unit at X16
A cannon shot can also be started independently of this input. Using the "cannon
shot" function, this is also possible via a prop. channel, nautic / multiswitch switch,
etc.
Output sequences
You can assign any number of outputs in up to eight sequence groups.
In the Sound-Teacher up to 36 steps can be programmed for each of the eight
sequences (see page 76). For every step, you can program which output is switched
on and the intensity of the outputs.
Moreover, the duration of every step until it goes on to the next one can be
configured.
Is an output sequence enabled, the sequence always takes precedence over the
normal function (eg, indicators, parking lights, etc.) of the output. The normal function
of the output is switched off during the active sequence.
With these output sequences, the most amazing light effects can be generated.
Examples:
• Rotating lights
• Moving lights
• Modern police flashlights
• Beacon lights for airplanes
• Switching on flickering of fluorescent lamps
• Any flickering lights and flash lights
Only one output sequence can be active at one time. A sequence stops as soon as a
new one is activated.
To Next Page
