GB Double Sound Speed Controller SFR-1-D
74 BEIER-Electronic 01.03.2020
The ship light functions can be configured to detect automatically the condition of "in
operation" or "at anchor" using the throttle channel #1. The condition "in operation" is
automatically switched off, if the throttle channel is in neutral for a defined time. After
the time has expired (1 – 255 s), it will be switched for example from "in operation" to
"at anchor".
The smoke generator can be activated automatically with the engine sound 1 or
engine sound 2. If this option is not used, the smoke generator needs to be switched
on/off separately with the function “smoke generator on”.
Three parameters can be used for the configuration of a smoke generator at output
X14:
• Smoke at engine cold/warm start and vehicle start:
This setting defines the smoke intesity while turning on the engine and during
a first acceleration.
• Smoke at idle position:
The value sets the smoke intensity in idle position.
• Smoke at full speed:
Sets the smoke intesity at a maximum speed. Between idle position and full
speed, the smoke intesity is adjusted proportionally.
For the output type “smoke generator fan” a trailing between 0 and 255 seconds can
be set. This helps to keep the hose free of condensation.
Configuration - Outputs - Light switch
With the light switch various lights can be controlled with the function "light switch +"
and "light switch -".
The light switch has in total 11 steps, which can be individually programmed. The
steps are divided in 6 positive and 4 negative steps. The number of steps that should
To Next Page
Loading...