GB Sound module USM-RC-3
82 BEIER-Electronic 11.10.2021
It can also be specified that indicators will turn off automatically after a certain
number of flashes.
The indicators can be activated fully automatically as soon as the vehicle is steered
and then deactivated again. The steering thresholds for this can be set or adapted
separately. Allowed values are 5 - 100 (%) and correspond to the steering angle. The
"Steering threshold indicator on" must be equal to or greater than "Steering threshold
indicator off".
If the „American indicator mode“ is activated, the indicators always light when the
parking light is on.
The indicator light threshold determines how strong the vehicle must turn until the
indicator light is activated. The higher the threshold, the stronger the vehicle must
turn in order to activate the indicator light.
The flashing rate for the indicators can be set, as well. The values for „on“ and „off“,
multiplied by 10 ms, is the duration of the light and dark phases of the indicator.
Bending lights:
If the option "Bendings light also work when the light is off" is not selected, then
either the parking light or the low beam headlight must be on for bending light to
work.
With the option "Bending light via steering on prop. channel #2" the bending lights
are automatically switched on while the vehicle is turning. The right bending light is
activated as long as the area "A" of prop. channel #2 is reached and is switched off,
if the area "A" is left. The left bending light is switched on, if the area "D" is reached
and is switched off again, when the area "D" is left.
The switching thresholds can be set below. Values between 5 and 100 are possible.
The option "Bending light via indicators" activates the bending light, as long as the
corresponding indicator is active. Both variants can be combined.
When driving backwards both bending lights can be activated automatically.
The bending lights can also be used as fog lights.
Daytime running light:
The daytime running light can be controlled with the light switch.
Optional, the daytime running light can only be activated when also the enigne sound
(1 and/or 2) is on.
If the option "Reversing light only when driving" is activated, the reversing warning
only lights up when the model is moving. The reversing light is then always off when
the vehicle is in stationary. The same applies to the reversing warning sound and the
automatic hazard warning lights.
To Next Page
Loading...