GB Sound module USM-RC-3
11.10.2021 BEIER-Electronic 83
If the option "low beam with xenon HID turn-on effect" is activated, the typical xenon
effect (short flash followed by dimming up) appears when turning on the low beam
headlight.
If desired, parking light and low beam headlight can always be switched on
automatically as soon as the engine sound is on. If this option is activated, however,
the parking light and low beam headlight can not be switched on or off, using the
functions "Parking light " or " Low beam headlight "!
The ship light functions can be configured to detect automatically the condition of "in
operation" or "at anchor" using the throttle channel #1. The condition "in operation" is
automatically switched off, if the throttle channel is in neutral for a defined time. After
the time has expired (1-255s), it will be switched for example from "in operation" to
"at anchor".
The smoke generator can be activated automatically with the engine sound 1 or
engine sound 2. If this option is not used, the smoke generator needs to be switched
on/off separately with the function “smoke generator on”.
For the output type “smoke generator fan” a trailing between 0 and 255 seconds can
be set. This helps to keep the hose free of condensation.
Configuration - Outputs - Light switch
With the light switch various lights can be controlled with the function "Light switch +"
and "Light switch -".
The light switch has in total 11 steps, which can be individually programmed. The
steps are divided in 6 positive and 4 negative steps. The number of steps that should
be used, can be selected as well as the active lights in each step. An active output is
indicated with a "" in the table.
To Next Page
Loading...