Need help?Do you have a question about the BeiJer X2 and is the answer not in the manual?
Details the Ethernet ports on the X2 control for Modbus TCP.
Guides on configuring the IP address for the X2 control's Ethernet ports.
Describes the Ethernet ports on the BFI-E3 and its versions.
Explains the meaning of LED indicators on the BFI-E3 Ethernet ports for status.
Details the configuration settings for the BFI-E3 module.
Provides information on network traffic statistics for the BFI-E3.
Displays communication statistics for Modbus, indicating operational health.
Instructions on how to modify the network interface settings of the BFI-E3.
Specifies essential parameters for Modbus TCP communication with BFI-E3.
Explains parameters for securing the BFI-E3 Ethernet interface.
Details the components and structure of the CODESYS/BCS Tools project.
Provides methods to enable or disable specific devices within the project.
Covers the configuration of Ethernet settings for communication in CODESYS/BCS Tools.
Lists and explains control and status registers for BFI-E3.
Details registers used for writing commands and parameters to BFI-E3.
Explains registers for reading drive status, serial numbers, and parameters.
Covers registers for accessing and modifying drive parameters indirectly.
Provides a comprehensive list of adjustable parameters and their settings.
Describes error codes and exception responses from the BFI-E3.
Lists register differences specific to single-phase output drives.
Provides contact details and a list of global offices and distributors.
General| Brand | BeiJer |
|---|---|
| Model | X2 |
| Category | Controller |
| Language | English |
To Next Page
