33 ©
BEKA 2019 All rights reserved!
BAL2576_BEKA_HAMAX_System2_0919DE_EN_FR
4.4 Obligations of the operator / user
If movable, rotating, hot or cold parts of the device bear risks, the customer must protect these parts against
contact. This protection must not be removed.
Any leakages of hazardous substances must be drained in a way that no risks for persons or the environment
arise. Please also refer to the data or safety data sheets of the respective manufacturers.
Observe all legal provisions.
Hazards due to electricity are to be excluded.
Examination of pipes and hoses regarding safe provision, use, proper assembly and function has to be carried out
according to regionally applicable directives. Inspection intervals may not be exceeded.
Defective pipes or hoses must be replaced immediately and professionally.
Hydraulic hoses and polyamide pipes are subject to natural aging and have to be exchanged in regular intervals
according to the manufacturer’s specifications.
A safety data sheet of the currently used lubricant must be provided at the device.
Observe the universally valid Ordinance on Hazardous Substances in its latest version.
4.5
Safety instructions for maintenance, inspection and assembly
All maintenance, inspection and assembly work may only be carried out by qualified personnel who is sufficiently
informed by thorough reading of the user information.
Any work at the device may generally only be carried out at complete standstill and in pressureless as well as
disconnected condition. Furthermore, appropriate personal protective equipment (goggles among others) is
necessary. The shutdown procedure of the device as described in the manual must be strictly followed.
Secure the device against intentional or unintentional recommissioning during maintenance or repair. All safety and
protection arrangements have to be put back in place again immediately after completion of the work.
Environmentally hazardous media must be disposed of professionally and according to the relevant legal provisions.
Polluted and contaminated surfaces have to be cleaned before maintenance. Please wear protective equipment to
that purpose. See the lubricant manufacturers‘ safety data sheets hereto, respectively the data sheets provided by the
manufacturers of auxiliaries and working materials.
Check the surface temperature of the device as a possible heat transfer bears the risk of burns. Wear heat resistant
protective gloves!
Open flame and fire are strictly forbidden during maintenance, inspection and repair due to fire hazard.
4.6 Unauthorized modification and production of spare parts
Modification, repair and alterations of the device are only accepted after manufacturer feedback. Original spare parts
and authorized accessories from the manufacturer contribute to safety. The use of other parts can result in the loss of
any liabilities for the resulting consequences. BEKA does not assume liability for parts that are retrofit by the operator.
4.7 Inadmissible modes of operation
Operational safety of the device is only guaranteed when it is appropriately applied as indicated in the operating and assembly manual.
Never exceed or fall below the limit values, as stated in the technical data.
4.8 General hazard warning – residual risk
All components are designed according to valid regulations for the construction of technical systems with regard to
operational safety and accident prevention. Nevertheless, their use can lead to hazards for the user or third parties as
well as other technical facilities. Therefore, the device may only fulfill its intended purpose in a technically perfect and
faultless condition. This has to happen in adherence to the relevant safety regulations as well as the operating and
assembly manual. Inspect the device and its attachment parts regularly and check them for possible damage or
leakages. Liquids could escape under high pressure from pressurized components which become leaky.
To Next Page
Loading...
Need help?
General
