35 © BEKA 2019 All rights reserved!
BAL2576_BEKA_HAMAX_System2_0919DE_EN_FR
6. Scope of warranty
Warranties regarding operational safety, reliability and performance will only be granted by the manufacturer if the device is used
according to the regulations and under the following conditions:
Assembly, connection and maintenance are only carried out by authorized and qualified staff.
The device is only used according to the operating and assembly manual.
Never exceed or fall below the limit values as defined in the technical data.
Modifications and repairs at the device may only be done by BEKA.
Guaranty and warranty will expire for any damage of the device caused by improper lubricant (e.g. wear of
piston, piston jamming, blockades, brittled sealings etc.).
BEKA will generally not accept guaranty claims for any damage caused by lubricants, even though those
have been laboratory tested and released by BEKA, as such damage (e.g. by over-stored or incorrectly
stored lubricants, batch fluctuations, etc.) cannot be verified or reconstructed later.
7. Transport and storage
Use suitable lifting devices for transport.
Do not throw the device or expose it to shocks.
Secure the device against toppling down or slipping during transport.
Observe all valid safety and accident prevention regulations for the transport. Wear suitable protective equipment if
necessary. Keep adequate distance to suspended loads. The transport help or the elevating device must have the
adequate carrying capacity.
When storing the device pay attention that the storage area is cool and dry in order to avoid corrosion of the
individual parts of the device.
Observe the storability of the lubricant contained in the cartridges. No longer use the cartridge when the
lubricant is over-stored (separation of oil and soap).
Notice!
Caution!
To Next Page
Loading...
Need help?
General
