Belkin G+MIMO - Manual Network Setup for Windows

72
G+ MIMO Wireless Modem Router
SECTIONSTable of Contents 1 2 3 4 5 6 8 9 107
MANUALLY CONFIGURING NETWORK SETTINGS
ManuallyConfiguringNetworkAdaptersinMacOSXv10.x 3. Next to “Configure” (2), if “Manually” is selected, your Router
will need to be set up for a static IP connection type� Write the
address information in the table below� You will need to enter this
information into the Router�
1. Click on the “System
Preferences” icon�
2. Select “Network” (1) from the “System Preferences” menu�
(1)
4. Select the “TCP/IP” tab (3)� Next to “Configure:” (4), you should see
“Manually” or “Using DHCP”� If you do not, check the PPPoE tab
(5) to make sure that “Connect using PPPoE” is NOT selected� If it
is, you will need to configure your Router for a PPPoE connection
type using your user name and password�
(4)
(5)
(3)
(2)