16 Bend-Tech Dragon A400
Startup Manual
Safety
01
1.3 Recommended PPE for Operating the Dragon A400
1.3.1 Eye Protection
Shaded safety glasses are required during cutting operations of the machine. Ensure the
shade is based on the amperage of the plasma torch being used. It is important the operator
and anyone observing the machine wear welder’s glasses or a welder’s mask. Placing a
welding curtain between the machine and other areas of the workspace is also recommended.
Refer to the Occupational Safety and Health Administration (OSHA) standards to determine
proper safety glass shading and/or welding curtain for the cutting torch amperage being used.
! Danger !
The cutting torch emits ultraviolet light. Looking directly at the plasma stream can
damage human retinas.
The minimum ANSI eye protection recommendations:
• Less than 40 amps - shade 5
• 41 to 60 amps - shade 6
• 61 to 300 amps - shade 8
For non-cutting operations, clear safety glasses are recommended.
1.3.2 Footwear
The Dragon A400 is a metal working machine and metal materials can be extremely heavy. A
piece of dropped material could cause injury to the operator or observers. Also, the Torch emits
sparks and possibly hot torch slag. It is highly recommended that the operator wear safety
shoes or boots while operating the Dragon A400.
1.3.3 Heat-Resistant Gloves
The plasma torch will introduce extreme heat into the material during the cutting process. The
operator should take caution handling newly-cut parts. Always wear heat resistant gloves when
handling parts produced by the Dragon A400.
To Next Page
Loading...
