Bend-Tech Dragon A400 - Control Screen E-Stop; Stop; Electrical Servicing; Power down before Servicing

21Bend-Tech Dragon A400
Startup Manual
Safety
01
1.6.2 Control Screen E-Stop
There is an additional emergency stop located on the machine control screen. This E-Stop
does not cut power to any motors or outputs, but will temporarily disable any software that
is being used. This will stop any project that is being run, without disconnecting power to the
motors.
1.6.3 Re-Home after an Emergency Stop
When an E-Stop is engaged, the machine will need to be re-homed after the E-Stop is cleared
and disengaged.
1.7 Electrical Servicing
1.7.1 Power Down Before Servicing
Completely power o󰀨 the Control Box before handling any electrical components. Electrical
components include all motor connections, motor cables, sensors, sensor cables, emergency
stops, laser cable, and Torch cable.
! Danger !
Do not touch 120VAC components inside the Control Box without rst disconnecting
the machine from its power source.
! Warning !
Never disconnect a Motor Cable with power applied.