Bend-Tech Dragon A400 - Material Weight; Weight Limit; Material Length; Material Support Lift

22 Bend-Tech Dragon A400
Startup Manual
Safety
01
1.8 Material Weight
1.8.1 Weight Limit
Material weight limit for the Dragon A400 should not exceed 400 lbs. This is the maximum
weight of material the Trolley can support while still operating safely.
! Danger !
Exceeding the material weight limit of the Dragon A400 can result in serious injury
to the Operator and/or bystanders.
! Caution !
Exceeding the material weight limit can a󰀨ect performance and possibly damage
the Dragon A400.
1.9 Material Length
1.9.1 Material Support Lift
Some non-rigid materials, or excessively long materials, can sag and cause material to raise
at the Toolhead. This introduces the danger of material contacting the Torch or damaging
the Engraver. Material longer than 10 ft. or thinner material may need to be supported by the
Material Support Lift in order to avoid contacting the Torch or damaging the Engraver.
1.10 Modications To The Machine
1.10.1 Unauthorized Modications
Performing unauthorized modications to the Dragon A400 is not recommended. Bend-Tech,
LLC is not responsible for damage resulting from modications to the Dragon A400.