26 Bend-Tech Dragon A400
Startup Manual
Maintenance
02
2.2.2 Clean the Support Beam
Clean the support beam using compressed air to blow any dirt or debris that may have
accumulated. After blowing o the support beam, clean the rails by wiping them down with a
clean rag.
2.2.3 Clean the Rack
Check the Rack for debris buildup and clean with compressed air. If the compressed air
strips the lubricant from the Racks, re-lubricate them with WD40 Specialist Spray & Stay Gel
Lubricant.
2.2.4 Check the Coolant Level
For Dragon machines equipped with a Material Cooling System, verify that the level of coolant
is adequate. Coolant can be clean water or other coolants, such as anti-rust solutions.
2.2.5 Clear the Part Catcher
Remove any loose parts from the Parts Catcher. Clean the Parts Catcher of slag and debris. If
necessary, add water to the Parts Catcher.
2.2.6 Check the Air Pressure
Check the air pressure at the air inlet on the Control Box. Pressure should be within the
recommended 100-130 psi range.
2.2.7 Clean the Work Area
It is important to keep the work area surrounding the Dragon A400 clean and free from dust
and safety hazards. Sweep the work area regularly and remove any debris that may be around
the machine.
2.2.8 Check the Plasma System
Refer to your plasma system maintenance guide regarding scheduled maintenance and
procedures.
2.3 Weekly or Every 40 Hours
Each week or 40-hours of runtime, the Dragon will require additional maintenance from the
Operator. Maintenance in this section should be combined with maintenance outlined in
section 2.2: Daily Maintenance.
2.3.1 Clean Grease and Oil Buildup
Wipe o any excess grease, oil or grime that may have accumulated on the machine.
To Next Page
Loading...
