18 Bend-Tech Dragon A400
Startup Manual
Safety
01
! Danger !
Servicing the plasma unit with power connected can result in electric shock which
can lead to severe injury or death. Disconnect power before servicing the torch or
plasma unit.
! Danger !
Do not use combustible fuel gases or oxidizing gases in the plasma cutting process.
Use of these types of gases can result in explosive conditions during cutting
operations.
1.4 Operational Safety
1.4.1 Guards
Do not operate the machine without safety guards in place.
1.4.2 Machine Inspection
Perform an inspection of the machine before each startup, making sure all electrical cords and
cables that function as part of moving assemblies are secure and fastened. Ensure all tools
are fastened securely. Ensure all E-stop switches are disengaged.
1.4.3 Machine Operational Movement
While a program is running, the Trolley and Toolhead can move rapidly at any time through its
short/long travel feed rate procedures. The operator and bystanders should stay clear of the
Trolley and Toolhead during machine operation.
! Warning !
The Trolley,Toolhead, and Gate are pinch points. Stay clear during machine
operation.
To Next Page
Loading...
