Bend-Tech Dragon A400 - Page 28

28 Bend-Tech Dragon A400
Startup Manual
Maintenance
02
2.4.4 Check the Emergency Stops
Inspect the E-Stop buttons for loose wire connections and proper operation. Check that each
E-Stop is functioning correctly. When an E-Stop is triggered the green power light will turn o󰀨.
2.4.5 Clean and Lubricate the Racks
Clean the Gear Racks and re-lubricate with WD40 Specialist Spray & Stay Gel Lubricant.
2.4.6 Check Backlash
Check backlash in X-Axis. Adjust if necessary.
2.5 Quarterly or 500 Hours
Quarterly maintenance should take place every three months or after 500-hours of operation.
Quarterly maintenance should include all previous maintenance procedures outlined.
2.5.1 Clean Coolant Screens
For machines equipped with a Material Cooling System, inspect and clean the system screens.
2.5.2 Grease Pillow Block Bearings
Reapply grease to the pillow block bearings on the Trolley. Bend-Tech recommends hi-temp
red lithium grease, NLGI2.
2.5.3 Comprehensive Cleaning
Clean entire machine.
2.6 Bi-Annually or 1000 Hours
Bi-annual maintenance should take place every six months or after 1000 hours of operation.
Bi-annual maintenance should include all previous maintenance procedures outlined.
2.6.1 Clean the Chuck
Remove the Chuck, disassemble jaws and clean. Ensure the teeth are reinstalled in the proper
location and in the proper order.
2.6.2 Check Level and Straightness
Check to ensure the Rail is level and adjust as necessary. Check the Rail for straightness
using the string provided with the machine. See Startup and Training Manual Part 2 section
1.2.3.