10AP Series Two-Post Lifts 12 P/N 5900265 — Rev. A6 — December 2022
Installation
The installation process includes multiple steps. Perform them in the order listed.
⚠ WARNING Use only the factory-supplied parts shipped with your Lift. If you use attachments,
accessories, or configuration modifying components that are in the path and/or
affect the operation of the equipment, affect the equipment’s electrical listing, or
affect the intended Vehicle accommodation, and if they are not certified for use
with this Lift, then you void the warranty of the Lift as well as compromising the
safety of everyone who sets up or uses the Lift. If you are missing parts, visit
BendPak.com/Support, email support@bendpak.com or contact BendPak
Technical Support at (800) 253-2363.
Reviewing the Safety Rules
When installing a Lift, your safety depends on proper training and thoughtful operation. BendPak
recommends referring to the ANSI/ALI ALIS Standard Safety Requirements for Installation and Service
for more information about safely installing, using, and servicing your Lift.
⚠ WARNING Do not install this equipment unless you have automotive lift installation training.
Always use proper lifting tools, such as a Forklift or Shop Crane, to raise heavy
components. Do not install this equipment without reading and understanding this
Manual and the Labels on the unit.
Only fully trained personnel should be involved in installing this equipment. Always pay attention. Use
appropriate tools and lifting equipment. Stay clear of moving parts.
⚠ WARNING You must always wear appropriate protective equipment during installation: leather
gloves, steel-toed work boots, eye protection, back belts, and hearing protection.
Gathering Your Tools
You may need some or all of the following tools:
Rotary hammer drill (or similar)
3/4-inch carbide bit (conforming to ANSI
B212.15)
Hammer
Four-foot level
Open-end wrench set, SAE, and metric
Socket and ratchet set, SAE, and metric
Hex-key wrench set
Crescent and pipe wrenches
• Crowbar
• Chalk line
• Medium-sized flat screwdriver
• Tape measure, 25 feet or more
• Needle-nose pliers
• Forklift or Shop Crane
• Two 12-foot ladders
• Two sawhorses
• Torque wrench
To Next Page
