10AP Series Two-Post Lifts 27 P/N 5900265 — Rev. A6 — December 2022
The opening in the Post Extension faces the inside of the Lift.
Secure the Post Extension to the Lift Post, using the hardware listed in the illustration above.
Slide on the other Post Extension to the other Lift Post and secure it the same way.
Hydraulic System Warnings:
⚠ DANGER Failure to observe these warnings can result in serious personal injury including, in
rare cases, death.
⚠ WARNING The Hydraulic Hoses and connections
must
be inspected before any attempt to
raise a Vehicle is made.
⚠ WARNING Double check to
verify
all Hydraulic Hose connections and fittings, including
unused auxiliary port plugs on the Power Unit, the Flow Divider, the Cylinders and
anywhere else in the Hydraulic System are tightened.
⚠ WARNING The Power Unit is a Hydraulic Pump capable of developing pressures in excess of
5,000 psi (345 BAR). A pressure relief valve is used to set the pressure at the
desired level. Tampering with, adjusting, modifying, or removing the relief valve is
extremely dangerous and is not recommended. Only trained Hydraulics Technicians
should adjust the relief valve, using calibrated Hydraulic Pressure gauges to assure
the proper pressure setting is achieved.
⚠ WARNING Changes to the output pressure may render the power unit incompatible with
pressure limitations of other components in the Hydraulic Circuit. This may cause
catastrophic failure of those components, and could result in property damage,
serious personal injury, or death.
⚠ DANGER The Hydraulic System can contain high pressure which, if suddenly released, can
cause serious injury or death.
⚠ WARNING Do
not
attempt to connect or disconnect Hydraulic Hoses while the equipment is
loaded, or while a Vehicle is on the Lift, or the Hydraulic System is under pressure.
⚠ WARNING Keep bare hands away from Hydraulic Fluid; always wear gloves when handling
Hydraulic Fluid, Cylinders or Hydraulic Hoses.
⚠ WARNING When handling Hydraulic Fluid, always observe the safety instructions from the
manufacturer.
⚠ WARNING Always promptly clean any Hydraulic Fluid spills. If a leak is the source of the spill,
lockout the Lift to prevent use until the Hydraulic System is repaired.
To Next Page
