P-9000LT/F Low-Rise Pit Lift 19 P/N 5900022 — Rev. B — Nov. 2019
Anchor the Bases
Both Bases have six holes in them for anchoring the Base.
Concrete specifications are:
• Depth: 4.25 inches / 108 mm thick, minimum
• PSI: 3,000 PSI, minimum
• Cured: 28 days, minimum
The Concrete floor where you want to install your Lift must meet the following requirements:
• The floor must be a flat, Concrete floor. It must be level;
do not install the Lift on a surface
with more than three degrees of slope
.
• Do not install Anchor Bolts into cracked or defective Concrete or on expansion seams. All Anchor
Bolts must be at least 6 inches away from expansion seams, control joints, or other
inconsistencies in the Concrete.
• Check the floor for the possibility of it being a post-tension slab. In this case, contact the building
architect before drilling. Using ground penetrating radar may help you find the tensioned cable.
⚠ WARNING Cutting through a tensioned cable can result in injury or death. Do not drill into a
post-tension slab unless the building architect confirms you are
not
going to hit a
tensioned cable or you have located it using ground penetrating radar.
If colored
sheath comes up during drilling, stop drilling immediately
.
Anchor Bolt specifications are:
• Length: 4.75 inches
• Diameter: ¾ inch
• Effective embedment depth: 2.75 inches, minimum
• Anchor torque: 85 – 95 pound feet (not less than 80 or more than 105)
⚠ WARNING
Only use the factory-supplied parts that came with your Lift
. If you use
parts from a different source, you void your warranty and compromise the safety of
everyone who installs or uses the Lift.
The following drawing shows the locations of the six Anchor Bolt holes in each P-9000LT Base.
Drawing not necessarily to scale. Not all components shown.
To Next Page
Loading...
