BendPak P-9000LT - Anchor Bolt Installation Steps

P-9000LT/F Low-Rise Pit Lift 20 P/N 5900022 — Rev. B — Nov. 2019
To anchor your Lift:
1. Make sure the Bases are in the correct location.
Once the Anchor Bolts are torqued into position, they are not easily removed. BendPak strongly
recommends making sure the Bases are in the correct location
before anchoring them into place.
2. Make sure the Platforms are raised to, and engaged on, the top Safety Lock.
3. This gives you room under the Platform to access the Anchor Bolt Holes in the Bases.
4. Using the Anchor Bolt Holes in the Bases as guides, drill each hole 4 in / 101 mm deep.
Note: If you prefer, you can mark the Anchor Bolt Hole locations, move the Bases out of the
way, drill the holes, and then move the Bases back into position.
Go in straight; do not let the drill wobble.
Use a carbide bit (conforming to ANSI B212.15-1994).
The diameter of the drill bit
must be the same as the diameter of the Anchor Bolt. So if you are
using a ¾ inch diameter Anchor Bolt, for example, use a ¾ inch diameter drill bit.
5. Use a vacuum to thoroughly clean each hole.
If a vacuum is not available, use a wire brush, hand pump, or compressed air.
Do
not ream the hole. Do not make the hole any wider than the drill bit made it.