P-9000LT/F Low-Rise Pit Lift 28 P/N 5900022 — Rev. B — Nov. 2019
10. Attach the Short End of either of the Hydraulic Hose Assemblies to one of the Hydraulic Elbow
Fittings you just attached, then attach the Short End of the other Hydraulic Hose Assembly to the
other Hydraulic Elbow Fitting.
⚠ CAUTION When installing the Hydraulic Hose Assemblies, make sure they are angled so they
end up against or very near to the Hydraulic Cylinders, not standing straight up.
Drawing not to scale. Some components not shown. Fittings shown not connected for clarity.
Finger tighten the connections.
11. Route the two Hydraulic Hoses from the Flow Divider to the Hydraulic Hose Assemblies
Finger tighten the connections.
12. Make sure both Hydraulic Hoses are correctly routed and do not have any kinks, then use
appropriate tools to
securely
tighten the finger-tightened connections.
To Next Page
Loading...
