EasyManuals Logo

BendPak XPR-10XLS Service Manual

Default Icon
47 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #46 background imageLoading...
Page #46 background image
2-Post Lifts (ALI approved) Product Decal Positioning
IMPORTANT: Please use materials as instructed
Prop_65_Label.pdf:
Size: 1.5”W x 1.5”H
Material: 4 Mil. Permanent White Adhesive Vinyl
Ink: U.V. protected CMYK 2/C Process
Finish: Matte Overlaminate (No gloss)
Print Process: Offset Lithography - 200 line-screen or 300 p.p.i. for digital
Lamination: Clear laminate non-glare medium matte over-laminate (No
gloss) for abrasion, chemical and ultra violet protection.
CALIFORNIA PROPOSITION 65
WARNING
WARNING! This product can expose
you to chemicals including styrene and
vinyl chloride which are on the list of
over 900 chemicals identified by the
State of California to cause cancer,
birth defects or reproductive harm.
ALWAYS use this product in accordance
with the manufacturer’s instructions.
For more information, go to
www.p65warnings.ca.gov.
PN 5905775
N
M
American_Owned_50_Years_Logo.pdf:
Trim: 4"W x 3"H
Material: 4 Mil Permanent White Adhesive Vinyl
Ink: U.V. protected CMYK 2/C Process
Finish: Matte Overlaminate (No gloss)
Print Process: Offset Lithography - 200 line-screen
or 300 p.p.i. for digital
Lamination: Clear laminate non-glare medium
matte over-laminate (No gloss) for abrasion, chemi-
cal and ultra violet protection.
GRAY DOES NOT PRINT
DOES NOT PRINT
DIE-CUT LINE
PN 5906044

Table of Contents

Other manuals for BendPak XPR-10XLS

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the BendPak XPR-10XLS and is the answer not in the manual?

BendPak XPR-10XLS Specifications

General IconGeneral
BrandBendPak
ModelXPR-10XLS
CategoryLifting Systems
LanguageEnglish

Related product manuals